|
To thoroughly clean a beach you need to
screen the sand, removing all the debris larger then the chosen
screen hole size. Screening is the only way to not only
completely clean the beach but aerates and conditions the sand,
while also reducing bacteria and e-coli.
If you don't see the cleaned sand returning
to the beach, that beachcleaner isn't a Cherrington or a quality
screening Beachcleaner. Only by this method of screening can you
be sure, that the trash was removed, not covered-up or buried by
a big groomer.
|
|
|
The 4500XL uses a slanted-one piece-non
rotating, oscillating screen. The screen oscillation is
driven from a simple, hydraulic drive, vibration motor mounted
on the underside of the screen. This almost undetectable
vibration, set at the perfect frequency for beach sand
screening, is revolutionizing Beachcleaning worldwide.
This method of Beachcleaning allows for
precision cleaning at speeds and depths like never before.
Screen seaweed, cigarette butts, trash, litter, and stones in
one quick pass.
Thoroughly cleaning the beach reduces
operating costs. This efficiency combined with the unmatched
design of only 3 bearings, makes maintenance costs the
lowest of all Beachcleaners.
More Info -
The single-screen beach cleaning / screening
system greatly reduces maintenance and improves life over
revolving tines or revolving mesh screen methods. The
screen life and effectiveness is further enhanced by positioning
the conveyor flights just above, but off the screen.
|
|
|
|
Keeping the flights off the screen is
achieved by the use of puck glides. This innovative design makes
for the fastest, most productive Beachcleaner in the world.
The 4500XL has a 1 yd. 8’ high-lift
hopper, the economical 4500 has a 1 yd. ground dump hopper,
which can later be easily converted to high-lift.Screening and
Sanitizing can be done to meet any requirement, 1”, ¾”,
½”, or 3/8”.
|
|
|
The 4500XL Beach Cleaner
has an overall cleaning width of five feet with the new single
point oscillating screen capable of deep cleaning 6 inches deep. |
|
|
|
|
Model 4500XL Beachcleaner
Specifications - Metric
|
Model 4500XL Beachcleaner
Specifications - Standard
|
|
|
Length: |
5.08
m |
|
|
Length: |
16
ft. 8 inches |
|
|
Width: |
2.49
m |
|
|
Width: |
8
ft. 2 inches |
|
|
Height: |
2.16
m |
|
|
Height: |
7
ft. 1 inch |
|
|
Weight: |
2336
/ 2558 kg |
|
|
Weight: |
5150
/ 5640 lbs |
|
|
Performance
Range Acres/Hr * |
|
3
- 7
|
|
|
Performance
Range Acres/Hr * |
|
3
-7
|
|
|
Interchangeable
Screen Width: |
1.52
m |
|
|
Cleaning
Width: |
5
ft. |
|
|
Cleaning
Depth:
|
Up
to 15 cm
|
|
|
Cleaning
Depth:
|
Up
to 6 inches
|
|
|
Grooming
Width: |
2.49
m |
|
|
Grooming
Width: |
8
ft. 2 inches |
|
|
Hopper
Capacity: |
0.88
m³ |
|
|
Hopper
Capacity: |
1.15
yd3 |
|
|
Hopper
Dump Height: |
Ground
/ XL
is 2.6 m
Hydraulic |
|
|
Hopper
Dump Height: |
Ground /
XL
is 8 1/2'
Hydraulic
|
|
|
Maximum
Cleaning Speed: |
Up
to 24 km/hr |
|
|
Maximum
Cleaning Speed: |
Up
to 15 mph |
|
|
Powered
By: |
Requires
Tractor min. 45 HP 4WD with PTO |
|
|
Powered
By: |
Requires
Tractor min. 45 HP 4WD with PTO |
|
|
Tow
Vehicle Requirements: |
Large Capacity, spline mounted pump, hydraulic
motor, flow control, and built in pressure relief
protection.
Flotation
tires are recommended and hydrostatic drive
preferred.Note that sand and soil surfaces vary, and all
tow vehicles must have sufficient tractionand flotation
for the particular sand or application in which they
operate. |
|
|